Home » Equipment News » How does the machining center turn on and return to the original point?

How does the machining center turn on and return to the original point?

Posted by: Chris Na 2021-05-26 Comments Off on How does the machining center turn on and return to the original point?

1. Boot

The main switch of the cnc machine tool should be closed, and the power switch of the voltage stabilizer, air source and other equipment should be turned on. The machining center controls the main power supply, pops out the emergency stop button by turning it to the right, and turns on the power supply of the operation panel until the machine tool is insufficiently prepared alarm disappears, then the start-up is complete.

Steel structure
2. Machine back to origin

The machine tool returns to the origin, the switch is selected to return to the origin, and the switch is selected to quickly move the switch to the appropriate frequency. Back to origin

cnc machine tools
Three, matters needing attention

Before starting again, check whether the machine tool is abnormal, whether the lubricating oil is enough, and all the lines are normal before starting

When returning to the origin, make sure that it does not collide with anything on the workbench. When returning to the origin, the sequence of movement must be followed.

Please keep the source and address of this article for reprinting:How does the machining center turn on and return to the original point?

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.:Cnc Machine Wiki,Thanks!^^